Will My Old Hot Water Heater Hoses Work with a New Heater?

A new hot-water heater may be rated for a higher temperature and higher pressure than your old one. Make sure your plumbing can handle the upgrade.

12th December 2013.
By Ed Sherman

Question: The photo I sent in shows the water heater on a friend of mine’s boat. He’s had great luck with his heater and by specification it looks pretty good, as it is all stainless-steel and should outlast the unit on my boat, which has a mild steel painted case that is beginning to rust out. I’d like to replace my unit with one like my friend’s, but do have a concern.

When replacing a hot-water heater with a newer model, make sure the hot-water hoses in your old system are capable of handling any increase in pressure.

When replacing a hot-water heater with a newer model, make sure the hot-water hoses in your old system are capable of handling any increase in pressure.

I did a little checking and found out that the pressure relief on the one on my friend’s boat is rated at 6 bar*, which by my calculation works out to just under 90 psi. I’m a little worried that my older hot water system, which uses reinforced PVC hoses, might not be able to handle this sort of pressure. Should I be worried?

Answer: You are quite observant. Most boat owners would never think of this as a potential problem. The answer isn’t really a yes or no, I’m afraid. It depends on a few things. The PVC semi-rigid hoses you show on your friend’s boat can certainly handle the pressure without incident, but you are right to question your older system. Raritan, for example, rated the pressure relief valves for its popular water heaters at 75 psi. Most systems operate at a maximum of 50-60 psi if all is well.

So, in your case, you will need to confirm that the hot-water side of your older system is at the least using hose rated for hot water, and in good condition. Trident, for example, makes several grades of FDA-approved potable water hose. Depending upon which grade you select, the hot-water ratings are for up to 150 degrees F and at least 150-psi pressures. They do recommend double clamping and using sealing compound on all the joints in the system.

So, as long as all your older equipment is still in good condition, you should be OK with the new-style water heater.

* Editor’s note: A bar is a unit of pressure measurement roughly equal to atmospheric pressure at sea level, or 14.7 pounds per square inch. So 6 bar is 88.2 psi.


Tags: , , ,

About the author:

Ed Sherman

Profile
Ed Sherman is a regular contributor to boats.com, as well as to Professional Boatbuilder and Cruising World, where he previously was electronics editor. He also is the curriculum director for the American Boat and Yacht Council. Previously, Ed was chairman of the Marine Technology Department at the New England Institute of Technology. Ed’s blog posts appear courtesy of his website, EdsBoatTips.
Website
http://www.EdsBoatTips.com

Comments are closed.

More Features

Catalina Ski Race Sees Big Records Tumble
Todd Haig easily breaks his ...
Simple Boating: Which is More Fun, Kayak or SUP?
A typical boater tells the ...

More News

Todd Haig easily breaks his own record on the 62-mile ...
Raymarine adds to your selection of side scan sonar systems ...

How To