Oyster 53: Bob Perry Review

Bob Perry reviews the Oyster 53

26th June 2003.
By Bob Perry

img866You have to hand it to the Oyster marketing team. If you say “raised saloon” you almost immediately follow it with “like an Oyster.” This reminds me of 20 years ago when it was: “You know, like a Swan.”

Rob Humphreys designed the hull, deck and rig; Holman and Pye did the interior and structural design. The Oyster 53 is a handsome boat with contemporary lines. The Department of Ergonomics at Loughborough University did the cockpit design. Oyster has drawn on a wide range of talent to produce this boat.

The biggest challenge in designing a raised-saloon boat is not the aesthetics. The real challenge is integrating the heights you need for the raised saloon with the clearances required to extend the saloon seating beyond the perimeter of the cabintrunk. If you want to sit and look out the windows, you have to bring the settees inboard and raise them up two steps, not one. This works well for visibility, but chops up the saloon and reduces the available space.

img865The saloon layout of this particular model pushed the settees outboard. This layout is termed the standard layout, but variations are available to suit owner requirements. The big circular dinette is impressive, but again, I’d prefer to see corners. Adjacent to the galley and separated by the engine room is a small stateroom with stacked single berths. There is another small stateroom forward with stacked berths. This means that along with the two palatial double-berth staterooms for the adults, there is sleeping for four kids. I like this. I can’t imagine many improvements to this layout. If the small stateroom aft was eliminated, it could be converted to a navigational/computer area, and you could add some additional useful space to the saloon settee to port. One way to judge a layout is to see if you can seat, at one table, the same number of people you can sleep. I can’t see eight people eating at that small circular table unless they were eating noodles, on end.

img864One benefit of the center-cockpit layout is that you can get the mainsheet traveler aft of the cockpit and out of the way. The mainsheet is led forward, inside the boom, then brought out to lead aft to a winch on the cabintop. The cockpit itself is on the small side, but this is part of the center-cockpit equation. The well will intrude into the interior, so it makes sense in an interior-driven design to keep the well small. I’d like to see more deck hatches on this boat, although given the layout of the deck I’m not sure how I would place them. That’s another problem with center-cockpit boats. There is an outside-opening port in the galley, and I would assume that there is an opening port into the cockpit well for cross-ventilation. Note the large deck access locker molded into the aft end of the trunk and the flush hatches accessing the lazarette.

img863The rig is a masthead sloop with a staysail for heavy weather. The spreaders are in-line and there is a babystay forward. Looking at the interior I can see that it would be easy to move the chainplates aft and to sweep the spreaders. This would do away with the need for the babystay and make tacking easier. But now you’re back to impaling the main on the spreaders. As my pal Special Ed says, “It’s always something, never nothing.” SA/D ratio is 18.99.

The hull is moderately heavy with a D/L ratio of 242. Remember, this ratio range is not static. The light boat of yesterday is the moderate boat of today. The 53 is beamy and carries the beam aft to help with accommodations, deck space and boat speed. What more could you want? Draft is either 7 feet, 3 inches or 6 feet, depending upon keel choice. The rudder is a nonbalanced, skeg-hung type. Note how narrow the skeg is.

I always go aboard the Oysters at boat shows. They have a nice feel and usually show careful detailing and choice of hardware. I think this new 53 epitomizes what a lot of cruising sailors are looking for today.

An attractively detailed, well-laid-out, center-cockpit cruiser.

img862Specifications

LOA 53’10″
LWL 45’1″
Beam 15’3″
Draft 7’3″ (standard keel), 6′ (optional shoal keel)
Displacement 49,600 lbs.
Ballast 14,010 lbs.
Sail Area 1,602 sq. ft. (main + genoa)
SA/D ratio 18.99
D/L ratio 242
L/B 3.53
Auxiliary Yanmar 88-horsepower diesel
Fuel 185 gals.
Water 198 gals.

Oyster Marine Ltd
Fox’s Marina
Ipswich
Suffolk
IP2 8SA
UK

Tel: +44(0)1473 688888
Fax: +44(0)1473 686861
Email: web.enquiries@oystermarine.com

Oyster Marine USA
5 Marine Plaza
Goat Island
Newport
RI 02840
USA

Tel: (001) 401 846 7400
Fax: (001) 401 846 7483
Email: info@oysteryachts.com

SAILINGlogo-115This story originally appeared in Sailing Magazine, and is republished here by permission. Subscribe to Sailing.

 

 


Tags: , , , ,

Comments are closed.

More Features

Mercury Debuts All-New 75 HP, 90 HP, and 115 HP FourStroke Outboards
These 2.1-liter series outboards are ...
On-Board Propane Hose Fittings
If you have a hose-clamped ...

More News

These 2.1-liter series outboards are lightweight, compact, powerful, thrifty and ...
Carbon-free luxury can now be found in aquatic limousines. Seriously.

How To